The SCS Climbing System is predominantly used for single-sided applications, i.e. with non-tied wall formwork. The loads resulting from the fresh concrete pressure are thereby transferred via the brackets into the previous concreting section by climbing anchors. Typical areas of applications for the SCS Climbing System are dams, locks, cooling towers, bunkers and strongroom vaults, pier heads and tunnels. With very few additional components, the brackets are also suitable for forming with anchored wall formwork.
Large, craneable climbing units
due to the particularly high load-bearing capacity of the brackets with good utilization of the anchoring
Material-optimized solution
with the same formwork and components for the starter and subsequent standard cycles
Safe, horizontal working areas
through inclinable platforms which can easily be adapted to suit inclined structural elements
Cost-effective also for two-sided applications
through a minimum of additional components for a high level of material utilization and reduced logistical requirements
Support structure for supporting non-tied, single sided wall formwork
With the SCS system, two bracket units together with one PERI wall formwork section form a cranemovable platform unit.
Optionally, VARIO GT 24 Girder Wall Formwork as well as TRIO or MAXIMO Panel Formwork can be used.
The SCS Climbing System has been optimized for a concreting height of 3.00 m (vertical applications) or 2.50 m (forward-inclined applications).
With only a minimum of additional components, the use with anchored formwork is also possible for walls up to 6.00 m high.
Addition of a finishing platform possible