Polyurethane glue Fix gun

PUfor woodfor concrete

Permanently elastic and moisture-curing solventfree single-component PU foamadhesive with excellent bonding properties. The PU foam is ready to use and self-expanding. Bonding IKO enertherm insulation boards to various substrates including profiled metal sheets, existing bitumen membranes, concrete, timber etc. Insulation boards with dimensions over 120cm x 120cm can’t be glued with IKO pro Fix gun. The air temperature and the product temperature should be between 5°C and 30°C. If necessary, the spray can be brought to the correct temperature by placing it in a bucket of cold or lukewarm water. The surface should be dry, stable, clean and free of any loose particle. Unevenesses in the substrate may not exceed 5 mm. Shake the spray vigorously for 30 seconds. Remove the protection cap and screw the spray to the IKO pro gun. The spray must be upside down while using the gun. Apply IKO pro Fix gun in beads with a 30 mm diameter along the contour of the panel material, and in a cross through the center of the panel. Apply the panel to the substrate within 5 minutes. The position of the panel can be corrected up to 15 minutes after applying the adhesive. Press the material well and depending on the application and weight, keep the pannel pressed, supported or temporarily fixed until the adhesive cures (2 hours). Avoid walking on or moving the insulation boards during the curing process of the adhesive. Check the adhesion of the insulation board prior to the application of the waterproofing and if in doubt, carry out an adhesion test.